Thermal Target for Zeroing (Pack of 10)

Thermal targets are essential for zeroing thermal scopes because, unlike traditional optics, thermal devices detect heat signatures, not visible light or ink on paper. A thermal target creates a high-contrast, glowing, or “cold” spot that is clearly visible against the environment, enabling precise identification of the aiming point and bullet impacts – the RIX Thermal Targets are the ideal solution to maximising the thermal scope zeroing procedures.

-How to use-
• Open the sealed package and take out the heat pad.
• Remove the anti-stick paper from the back side of the heat pad.
• Stick the heat pad directly to the target in the desired location.
• Perform zeroing procedure as described in the user manual of you thermal imaging device.

-Attention-
• The heat pack is air-actived, do not open the pad packaging until you are ready to use it.
• Do not cut or damage the heat pad while taking it out.
• There is no need to shake the heat pad, it will warm itself up in 2 – 4 minutes.
• The duration of the pad remain hot is 20-40 minutes (depending on the weather condition).